SNAPTOGGLE® Zinc-plated Steel Toggle Bolts (RoHS-compliant) 24100

Our SNAPTOGGLE® anchors get their name from their speed and ease of use—they work in a SNAP!

The third generation of our patented SNAPTOGGLE anchors has these improvements:

new longer and stronger plastic straps that now work in base materials 3/8″ to 3 5/8″ thick and will not break prematurely like other plastic straps
straps that snap off flush with the wall every time, assuring precise alignment
a new plating that is 7x more corrosion-resistant than B633-85 Type III/Sc 1 government spec zinc plating
The trivalent zinc plating on ALL of the SNAPTOGGLE anchors is RoHS-compliant
[Also available in 304 stainless steel]

100 BATM 3/16-24 toggle bolts (3/8″ – 3-5/8″ grip range) & 100 3/16-24 x 2½” combo head bolts.

Drill a 1/2″ (Ø13mm) hole. Hold metal channel flat alongside plastic straps and slide channel through hole. Minimum clearance behind wall: 1-7/8″ (48mm).

Hold ends of straps between thumb and forefinger and pull toward you until channel rests flush behind wall. Slide plastic cap along straps with other hand until flange of cap is flush with wall.

Snap straps at wall by pushing side to side, snapping off straps level with flange of cap.

Place item over flange. Insert bolt through item and tighten until flush against item, then stop.

Use machine screw or bolt to match thread in channel: BA (3/16″-24), BB (1/4″-20), BM5 (M5), and BM6 (M6).
Bolt length = item thickness + wall or ceiling thickness + 1/2″ (13mm)